NL / ENLog in
Contents
  1. 0How it fits together
  2. 1Create the project
  3. 2Component Onboarding
  4. 3Indexing of Datapoint lists (for BMS)
  5. 4Data exploration
  6. 5Install the Link
  7. 6Network settings
  8. 7Wired connection to installation components
  9. 8On-site onboarding
  10. 9Optimize
  11. 10Use the platform
Reference
Chapter 6 · Network settings

Network settings

Ethernet ports

The Link has two Ethernet ports on its bottom: ETH1 is the white port in the middle, ETH2 is the black port next to it.

ETH1white ETH2black Power LEDs RS485

Network configurations

There are several network configurations to choose from depending on the requirements and preferences for this installation. The following table provides an overview of the options. The pages that follow describe each configuration in detail.

Description 4G ETH1 ETH2 External switch needed
4G internet with Link installation network Internet Installation components Installation components More than 2 components
4G internet with existing installation network Internet Installation components via existing network Not used n.a.
Wired internet with Link installation network Not used Internet Installation components More than one component
Wired internet with existing installation network Not used Internet and installation components Not used n.a.
PreviousPower the Link Next4G internet with Link installation network