Indexing Modbus RTU datapoints

Configure the protocol address. Select the protocol Modbus RTU, select the Modbus RTU bus and enter the Slave ID (1 to 247) of the BMS you are connecting to. Then click Create Address.

If the installation has more than one Link, make sure the right one is selected under Link Hardware: the Link that is connected to the BMS you want to index.

Component Onboarding
Link Hardware
INT-ML-01-18
Step 1: Configure Protocol Address
Protocol
Modbus RTU
Modbus RTU Configuration
Modbus RTU Bus
Select a Modbus RTU bus
Slave ID
Enter Slave ID (1-247)
Create Address
BackSkip - no protocol address needed
Upload the datapoint list. After you have set up the address, upload the datapoint list of the BMS under Datasheet. You can also add diagrams; they are optional.

Make sure the first row of the CSV holds the column names. See Prepare the file.
Start the classification. Once you have uploaded the file, click Start Classification.